如何让Linux udev与Hyper-V IC合成网络驱动程序配合使用

由于 this question,我设法让Debian 6.0.1与Microsoft Hyper-V合成驱动程序一起使用.但是,如果我不从/etc/udev/rules.d/70删除合成以太网卡的条目-persistent-net.rules在每次启动时,VM都不会在下次启动,因为在mm / mmap.c有一个内核BUG：2129(递归故障) – 最后一个sysfs文件：/ sys / devices / vmbus_0_0 / vmbus_0_3 /网/的eth0 / UEVENT

我该如何解决？

编辑：

75-persistent-net-generator.rules看起来像这样：

# These rules generate rules to keep network interface names unchanged
# across reboots and write them to /etc/udev/rules.d/70-persistent-net.rules.

# variables used to communicate:
#   MATCHADDR           MAC address used for the match
#   MATCHID             bus_id used for the match
#   MATCHDRV            driver name used for the match
#   MATCHIFTYPE         interface type match
#   COMMENT             comment to add to the generated rule
#   INTERFACE_NAME      requested name supplied by external tool
#   INTERFACE_NEW       new interface name returned by rule writer

ACTION!="add",GOTO="persistent_net_generator_end"
SUBSYSTEM!="net",GOTO="persistent_net_generator_end"

# ignore the interface if a name has already been set
NAME=="?*",GOTO="persistent_net_generator_end"

# device name whitelist
KERNEL!="eth*|ath*|wlan*[0-9]|msh*|ra*|sta*|ctc*|lcs*|hsi*",\
                                        GOTO="persistent_net_generator_end"

# ignore Xen virtual interfaces
SUBSYSTEMS=="xen",GOTO="persistent_net_generator_end"

# ignore UML virtual interfaces
DRIVERS=="uml-netdev",GOTO="persistent_net_generator_end"

# ignore "secondary" raw interfaces of the madwifi driver
KERNEL=="ath*",ATTRS{type}=="802",GOTO="persistent_net_generator_end"

# ignore "secondary" monitor interfaces of mac80211 drivers
KERNEL=="wlan*",ATTRS{type}=="803",GOTO="persistent_net_generator_end"

# by default match on the MAC address and interface type
ENV{MATCHADDR}="$attr{address}"
ENV{MATCHIFTYPE}="$attr{type}"

# match interface dev_id
ATTR{dev_id}=="?*",ENV{MATCHDEVID}="$attr{dev_id}"

# These vendors are known to violate the local MAC address assignment scheme
# Interlan,DEC (UNIBUS or QBUS),Apollo,Cisco,Racal-Datacom
ENV{MATCHADDR}=="02:07:01:*",GOTO="globally_administered_whitelist"
# 3Com
ENV{MATCHADDR}=="02:60:60:*",GOTO="globally_administered_whitelist"
# 3Com IBM PC; Imagen; Valid; Cisco; Apple
ENV{MATCHADDR}=="02:60:8c:*",GOTO="globally_administered_whitelist"
# Intel
ENV{MATCHADDR}=="02:a0:c9:*",GOTO="globally_administered_whitelist"
# Olivetti
ENV{MATCHADDR}=="02:aa:3c:*",GOTO="globally_administered_whitelist"
# CMC Masscomp; Silicon Graphics; Prime EXL
ENV{MATCHADDR}=="02:cf:1f:*",GOTO="globally_administered_whitelist"
# Prominet Corporation Gigabit Ethernet Switch
ENV{MATCHADDR}=="02:e0:3b:*",GOTO="globally_administered_whitelist"
# BTI (Bus-Tech,Inc.) IBM Mainframes
ENV{MATCHADDR}=="02:e6:d3:*",GOTO="globally_administered_whitelist"
# Realtek
ENV{MATCHADDR}=="52:54:00:*",GOTO="globally_administered_whitelist"
# Novell 2000
ENV{MATCHADDR}=="52:54:4c:*",GOTO="globally_administered_whitelist"
# Realtec
ENV{MATCHADDR}=="52:54:ab:*",GOTO="globally_administered_whitelist"
# Kingston Technologies
ENV{MATCHADDR}=="e2:0c:0f:*",GOTO="globally_administered_whitelist"

# ignore interfaces with locally administered or null MAC addresses
# and KVM and VMWare virtual interfaces
ENV{MATCHADDR}=="?[2367abef]:*",ENV{MATCHADDR}=""
ENV{MATCHADDR}=="00:00:00:00:00:00",ENV{MATCHADDR}=""
ENV{MATCHADDR}=="00:0c:29:*|00:50:56:*",ENV{MATCHADDR}=""
ENV{MATCHADDR}=="52:54:00:*|54:52:00:*",ENV{MATCHADDR}=""

LABEL="globally_administered_whitelist"

# ibmveth interfaces have stable locally administered MAC addresses
SUBSYSTEMS=="ibmveth",ENV{MATCHADDR}="$attr{address}"

# S/390 interfaces are matched only by id
#SUBSYSTEMS=="ccwgroup",\
#       ENV{MATCHDRV}="$driver",ENV{MATCHID}="$id",ENV{MATCHADDR}=""

# terminate processing if there are not enough conditions to create a rule
ENV{MATCHADDR}=="",ENV{MATCHID}=="",ENV{INTERFACE_NAME}=="",\
                                        GOTO="persistent_net_generator_end"


# provide nice comments for the generated rules
SUBSYSTEMS=="pci",\
 ENV{COMMENT}="PCI device $attr{vendor}:$attr{device}"
SUBSYSTEMS=="pcmcia",\
 ENV{COMMENT}="PCMCIA device $attr{card_id}:$attr{manf_id}"
SUBSYSTEMS=="usb",\
 ENV{COMMENT}="USB device 0x$attr{idVendor}:0x$attr{idProduct}"
SUBSYSTEMS=="ccwgroup",\
 ENV{COMMENT}="S/390 device at $id"
SUBSYSTEMS=="ibmveth",\
 ENV{COMMENT}="LPAR virtual device at $id"
SUBSYSTEMS=="ieee1394",\
 ENV{COMMENT}="Firewire device $attr{host_id}"
ENV{COMMENT}=="",\
 ENV{COMMENT}="Unknown $env{SUBSYSTEM} device ($env{DEVPATH})"
ATTRS{driver}=="?*",\
 ENV{COMMENT}="$env{COMMENT} ($attr{driver})"


# ignore interfaces without a driver link like bridges and VLANs,otherwise
# generate and write the rule
DRIVERS=="?*",IMPORT{program}="write_net_rules"

# rename the interface if requested
ENV{INTERFACE_NEW}=="?*",NAME="$env{INTERFACE_NEW}"

LABEL="persistent_net_generator_end"

解决方法

我认为试试这个,基于 a Debian forum post

mkdir /lib/udev/rules.d/disabled 
mv /lib/udev/rules.d/75-persistent-net-generator.rules /lib/udev/rules.d/disabled 
mv /lib/udev/rules.d/75-cd-aliases-generator.rules /lib/udev/rules.d/disabled 
rm -f /etc/udev/rules.d/70*