CentOS 5.8 | VMWare ESX 5.1
当我运行ethtool eth0时,我看到以下内容:
[root@foo ~]# ethtool eth0 Settings for eth0: Current message level: 0x00000007 (7) Link detected: yes
有没有办法得到其余的细节?特别是速度和双工?我习惯于ethtool输出更冗长.例如:
# ethtool eth0 Settings for eth0: Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: Twisted Pair PHYAD: 1 Transceiver: internal Auto-negotiation: on Supports Wake-on: d Wake-on: d Link detected: yes
我想知道这是否与在VMWare平台上运行有关? ESX中的当前适配器类型为“灵活”,并且服务器上未安装VMWare工具.
解决方法
我想它没有报告任何PHY设置,因为没有任何,没有链接模式,没有autoneg,没有固定的速度,没有端口或布线类型,没有收发器等使用paravirtual驱动程序时
版权声明:本文内容由互联网用户自发贡献,该文观点与技术仅代表作者本人。本站仅提供信息存储空间服务,不拥有所有权,不承担相关法律责任。如发现本站有涉嫌侵权/违法违规的内容, 请发送邮件至 dio@foxmail.com 举报,一经查实,本站将立刻删除。